PH Plus Granules 1Kg

Description:

pH Plus (Sodium Carbonate) should be used to maintain the correct pH of your hot tub water. It should be used when the water is too acidic and needs to be reduced. The ideal range is between 7.2 – 7.6
We recommend that you use Hot Tub Test Strips daily to test the pH of your water.

Instructions for Use:

• Acid/alkaline conditions are measure on the ‘pH’ scale which ranges from 0 to 14.
• Ideal bathing conditions exist at a slightly alkaline level of 7.2 to 7.6 with total alkalinity of 80/120mg/litre (ppm). This range will also allow most effective use of other swimming pool chemicals.
• Use a Test Kit to establish the pH value of the pool water.
• If the reading is below 7.2, add this product at the rate of 500g (10oz) per 45m3 (10,000 gallons) of pool water. For spas add at a rate of 25g per 2.27m3 (500 gallons).
• Always pre-dissolve the product in warm water following the instructions below.
• Continue filtration and re-test after approximately 24 hours.
• If necessary, repeat treatment until reading of between 7.2 and 7.6 is obtained.
• The inability to maintain pH levels may indicate a water imbalance. In such cases consult your pool specialist.

General Precautions:

Never mix with any other chemicals including cleaning products, weedkillers and chlorine products, as a dangerous reaction may occur.Always handle products in a well ventilated area, preferably outdoors. When pre-dissolving products always use a clean plastic container. If in doubt wash thoroughly before use. When dissolving products always add product to water and not vice versa. Use only 100g of product per 10 litres of water each treatment. Repeat treatments if required.Always wash hands thoroughly after handling pool chemicals. Store in a cool dry place. Ensure chemicals do not become damp in storage. Instructions and dosages given are a guide for most effective use.

SAFETY

DANGER: NEVER MIX HOT TUB CHEMICALS TOGETHER
Always add chemicals to water and not water to chemicals