Stain and Scale Remover 0.5L

Mineral precipitation can cause stain and scale deposits that can build up on your hot tub's surfaces under certain conditions. Stain & Scale Inhibitor is a sequestering agent that helps prevent dissolved solids from precipitating.

Instructions for Use:

• Stain & Scale Inhibitor is very concentrated, for initial dose dilute 150ml  per 1m3 (1,000 litres) and then top up with 50ml per 1m3 (1,000 litres). Use on a regular basis, once every two weeks or more if required.
• Following the instructions below, pour evenly around the edge of the pool or spa.
• For visible stains or scale, dilute 250ml per 1m3 (1,000 litres) for hot tubs. Brush affected area after application. More than one application may be required.
• Some temporary cloudiness may be evident. Run filter as normal and continue until water clears.

General Precautions:

Never mix with any other chemicals including cleaning products, weedkillers and chlorine products, as a dangerous reaction may occur.Always handle products in a well ventilated area, preferably outdoors. When pre-dissolving products always use a clean plastic container. If in doubt wash thoroughly before use. When dissolving products always add product to water and not vice versa. Use only 100g of product per 10 litres of water each treatment. Repeat treatments if required.Always wash hands thoroughly after handling pool chemicals. Store in a cool dry place. Ensure chemicals do not become damp in storage. Instructions and dosages given are a guide for most effective use.

SAFETY